Smart-power-systems ER Series Manual de usuario descargar pdf (Pagina 17)

Smart Power

Systems

A. C. MODULAR GENERATOR SYSTEM

Page 16 of 52

Installation Guide

1. Mount the pump securely to the Power Take-Off (PTO). This may require attaching

a mounting bracket to the PTO housing prior to mounting the pump.

WARNING:

Always mount the hydraulic pump in a position with the pump controls up.

Mounting the pump in any other orientation will not allow hydraulic fluid in the

pump to reach the correct level before starting, causing premature wear of the

pump, thus voiding the system’s warranty. The pump and undercarriage

components will corrode if they are left unprotected. It is advisable to paint them

before completing the installation.

2. Locate and bore mounting holes for generator tray assembly as shown in Figure 6.

Maintain minimum clearances as indicated in Error! Reference source not found.,

Error! Reference source not found., Figure 3, and Figure 4.

OIL FILTER

ACCESS PANEL

11.64

7.25

2.06

32.00

33.50

.75

.56

4 PL.

Hole pattern for mounting ER-6.2, ER-8, ER-10and ER-110 tray assemblies

Figure 6

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 52 53

Sin comentarios

Smart-power-systems ER Series Manual de usuario Pagina 17